The 1st and easiest method is to download the latest driver source code and compile it against an existing kernel. After a new driver has been created, it is necessary to create new initial ramdisk s before rebooting the system. The 2nd method involves a kernel upgrade.
To ensure highest compatiblity and functionality, it is best to use matching driver and firmware revision as defined in 3ware Software Suites below:. Firmware and driver upgrade for 3ware Escalade controllers There are two ways to upgrade the controller firmware. Apparently the driver is for some of the earlier versions of 3ware controllers. Copy resulting 2. Reboot, select Xen 3. The following options were uncommented and set:.
A number of HVM guests were configured and installed using disk images of their corresponding install CDs. A separate logical disk partition was created for each HVM guest tested. Click the Forwarders tab 4. Click Edit , and add your external DNS servers like 4. DHCP 1. Expand IPv4 and right-click, click New Scope from the menu. Enter an IP range, ex: The remaining settings can be default for now. Domain name and DNS should be pre-configured.
WINS does not need to be configured at this time. Click Finish to complete the wizard. Refresh and IPv4 should have a green circle with a white check mark. Note: You will get a certificate error when accessing the IPFire management page. Nothing special here. VirtualBox 5. This is a major update. A little late, released March 4, a maintenance release. Adding them post-install is easier for me than making another custom ISO.
Blogroll essjae. Click Next. Enter MB for memory. Select Dynamically allocated and click Next. Change the location here if necessary. The 10GB default is large enough, click Create. Once created, click Settings and then click Network. We need to modify the networking options. Adapter 1 should be set to NAT or Bridged. Adapter 2 needs to be enabled and set to Internal Network. You can find it by expanding the Advanced tab.
Click Storage. Select to mount. Click Ok to close the window. Power on the VM. Follow the IPFire prompts.
0コメント